 |
 |
Language |
FAQ
Dosing and Mixing
Q1.When using regrind materials in SMS-50, the regrinding could not drop normally. Please provide solution.
The diameter of detecting pipe is just 50mm, the regrinding too big and too much dust to pass through the detecting pipe.
Please use the screen whose hole diameter is less than 8mm and dust separator.
Please use the screen whose hole diameter is less than 8mm and dust separator.
Q2.The throughput on this machine is about 1200kg/hr and the screw test weight is 160g, how do I set the parameter of F-03 for SCM?
Please note that the unit of F-03 is g/min for extruder while not kg/hr. So the right value of F-03 should be 20000g/min (1200*1000/60=20000g/min). Now you can set the unit of F-09 as 100g, and then the F-09 should be 1.6g and F-03 should be 200g/min.
Q3.Is it possible to install a set (screw) D.12 or 16 mm on a model SCM-38-14 or SCM-75-14? What is the capacity of main hopper?
The main structure is same for every model, that is to say, the different screw can be used in each unit.
The main hopper capacity is about 15 liters.
The main hopper capacity is about 15 liters.
